Forane? 365mfc

Forane? 365mfc, 1,1,1,3,3-pentafluorobutane is a liquid, SNAP approved HFC solvent available for use as component in solvent blends to replace HCFC-141b in precision cleaning, electronics cleaning, and carrier applications.

Advantages of using HFC-365mfc:

? Compatible with most metals, plastics, and elastomers 

? Good co-solvent 

? EPA SNAP approved for solvent use 

? Low toxicity 

? Environmental profile: non-VOC, zero ODP, low GWP 

? Low cost relative to other commercially available alternatives 

Applications

·         Carrier applications

·         Electronics cleaning

·         Precision cleaning 

Forane HFC-365mfc, 1,1,1,3,3-pentafluorobutane is a liquid, SNAP approved HFC solvents available through Arkema for use as components in solvent blends to replace HCFC-141b in precision cleaning, electronics cleaning, and carrier applications.

Advantages of using Forane HFC-365mfc:

?  Good co-solvent
?  EPA SNAP approved for solvent use
?  Low toxicity
?  Environmental Profile: Non-VOC, Zero ODP, Low GWP
?  Low cost relative to other commercially available solvent alternatives

Physical Properties of Forane? HFC-365mfc (72K PDF)

Plastics & Elastomers Compatibility (88K PDF)

Impact on Environment

Compared to HCFC-141b, Forane HFC-365mfc is more environmentally friendly. The following table compares the Ozone Depletion Potential (ODP) and Global Warming Potential (GWP) of HCFC-141b and HFC-365mfc.

* The individual components, HFC-365mfc and HFC-4310mee, have a GWP of 910 and 1300 respectively.

Forane HFC-365mfc has low toxicity and is not listed as Volatile Organic Compounds (VOCs). It has been specifically exempted by the EPA from VOC Regulations because of its negligible photochemical reactivity. Forane HFC-365mfc is listed on the TSCA inventory. HFC-4310mee (1,1,1,2,2,3,4,5,5,5-Decafluoropentane, CAS# 138495-42-8) is controlled by TSCA, Section 5, Significant New Use Rule (SNUR; 40 CFR 721.5645). The approved uses are:  Precision and general cleaning, carrier fluid, displacement drying, printed circuit board cleaning, particulate removal and film cleaning, process medium, heat transfer fluid (dielectric and non-dielectric), and test fluid. Processors and users of this substance must also comply with the applicable general SNUR requirements set forth in 40 CFR 721 subpart A, including export notification requirements if applicable (40 CFR 721.20), and the applicable record keeping requirements set forth at 40 CFR 721.125.